We regularly get called out to homes with genuinely good home theatre equipment that sounds flat or looks messy — not because the gear is bad, but because of how it was set up. Auztech Security sees this constantly, and it’s almost always fixable without replacing anything.
Where Home Theatre Setups Usually Go Wrong
- Speakers placed for convenience, not sound. Surround sound depends on positioning relative to your seating, not just where a shelf happens to be.
- No calibration. Even well-placed speakers need levels and delay set correctly for the room, which most off-the-shelf setups skip entirely.
- Cabling as an afterthought. Power, HDMI, and speaker cable run loosely rather than planned and concealed from the start.
- Mismatched components. A high-end screen paired with an underpowered receiver, or speakers the AV receiver can’t properly drive.
- Nobody accounting for future additions. A streaming box or console added later with no sensible way to connect it in.
What Proper Installation Actually Covers
Equipment recommendations matched to your room size and budget, concealed wiring for power, HDMI, and speaker runs, TV wall mounting at the correct height and angle, genuine speaker placement and calibration for real surround sound, and streaming/source setup so everything works from one remote or app — not five.
Planning a New Build or Renovation?
This is the cheapest point to plan a home theatre properly, running speaker and power cabling as part of pre-wiring before walls close up, rather than retrofitting cable runs into a finished room later.
Why Choose Auztech Security
The same licensed team installing your CCTV or alarm handles home theatre, TV mounting, and network setup — one point of contact for your whole home, with 15+ years of hands-on installation experience behind it.
Get Your Setup Actually Sounding Right
Contact Auztech Security
Website: https://www.auztechsecurity.com.au/
Phone: 03 9056 9046 / 0452 489 406
Email: sales@auztechsecurity.com.au
In most cases, yes. Poor sound is usually a placement and calibration issue, not a hardware issue — we assess your existing setup first before recommending any new equipment.
Mounting just gets a speaker onto a wall or shelf. Calibration sets the levels, delay, and crossover correctly for your specific room shape — that’s the step most installs skip, and it’s what actually creates real surround sound rather than just louder audio.
Placement is based on your seating position and room dimensions, not where a shelf or alcove happens to be convenient. We map this out during the on-site assessment before anything is fixed in place.
Yes. We regularly work with equipment customers have already purchased, and we’ll tell you honestly if anything is under- or over-specced for your room before we proceed.
Both. Most of our home theatre call-outs are actually existing homes with a setup that was never done properly the first time — not new installations.
Yes — concealing power, HDMI, and speaker cabling into the wall or a discreet channel is a standard part of getting the setup right, not an optional extra.


